TTZ10S YTZ10S Battery Original Yuasa Honda CBR 600 F 2007. The description of this item has been automatically translated. Online since 2000 – over 15,000 positive feedbacks. TTZ10S YTZ10S ORIGINAL yuasa BATTERY WITH ACID HONDA CBR 600 F 2007. Brand batteries yuasa are synonymous with performance, power and reliability. The batteries yuasa they are the most used ever as original equipment batteries by the most famous manufacturers in the world and are committed to yuasa has always been focused on satisfying the needs of motorcycle manufacturers, responding with cutting-edge technologies to the increasingly demanding demands of the market. The number 1 choice of bikers is yuasa, for those who always want the best, in all conditions. This battery is supplied with acid supplied and with the relative assembly and installation instructions, shown below: a Make sure the battery is placed on a flat surface. B Remove the bottles containing acid from the plastic bag and uncork the bottles taking care to keep the sealing strip, to be used later to cap the battery. ATTENTION: DO NOT REAR OR PUNCTURE THE SEALED POINTS OF THE BOTTLES. C Turn the bottles containing the acid upside down by matching the six sealed points perfectly with the holes in the battery. Apply light pressure to the bottles to open the sealed spots. D Make sure that there is rising air bubbles from one or more filling holes. ATTENTION: DO NOT TILT THE VIALS CONTAINING ACID AS THE FILLING OPERATION COULD BE INTERRUPTED. E If there is no rising air bubbles from any of the six filling holes, lightly tap the bottom of the bottles to facilitate the emptying operation. F Make sure that the bottles have completely emptied and tap on the bottom of the bottles in case there is still acid left on the bottom of the bottles. G Let the acid flow out for 60 minutes for batteries up to 18 AH and 2 hours for batteries over 18 AH. H Charge the battery for 6 hours and after having left it to rest for about 1 hour, seal it with the closure strap supplied by proceeding as follows: position the closure strap (acid bottle sealing strap) in the filling holes and press vertically with both hands, keeping the band horizontally. ATTENTION: this type of closure must no longer be removed in order not to compromise the seal of the battery. Charge/Recharge: 1/10 of rated capacity (Ah) with constant current linear charger. Loading example: Charge a 10 Ah battery with a value of 1 Ah, i. One tenth of the nominal capacity. ATTENTION: do not charge the battery with a maintainer but only use the product described above. WARNING: ILLUSTRATIVE IMAGE ONLY. For correct installation, always connect the positive pole first and then the negative one. We decline all responsibility for any direct, indirect or incidental damage linked to the use, proper or improper, of the information contained in this information sheet. ATTENTION: THE OPERATION MUST BE CARRIED OUT EXCLUSIVELY BY EXPERT PERSONNEL, CAREFULLY FOLLOW THE INSTRUCTIONS INDICATED ABOVE. Feedback is very important to us and helps us to offer a better service to buyers: We kindly ask you to. For any problem, before leaving negative or neutral feedback. If you do not express your satisfaction with. You can penalize us! It is a safe and certified method. We decline all responsibility for any accident that may occur due to and/or during the use of our products. In the event of accidents deriving from manufacturing defects, the guarantee, by express agreement, is limited to the replacement of the parts recognized by us as defective with the exclusion of any form of compensation. Any complaints received after 8 days from receipt of the goods cannot be satisfied. STYLMOTO therefore reserves the right to modify/adapt the technical and dimensional information of the products in the catalogue, based on what will be communicated by the producers, even without any notice. We decline all responsibility for direct or indirect damages deriving from the information provided. Via Battaglia di S.